Product Characteristics Of Solar Submersible Pumps

Aug 16, 2023 Leave a message

1. Brushed solar submersible pump
When the water pump is working, the coil and commutator rotate, while the magnetic steel and carbon brush do not rotate. The alternating changes in the current direction of the coil are completed by the commutator and brush that rotate the motor. As long as the motor rotates the carbon brush, wear will occur. When the computer water pump runs to a certain extent, the gap between the wear of the carbon brush will increase, and the sound will also increase. After running for several hundred hours continuously, the carbon brush cannot play the role of reversing.
Advantages: Low price.
2. Brushless motor solar submersible pump
The electric brushless solar submersible pump is composed of a brushless DC motor and an impeller. The shaft of the motor is connected to the impeller, and there is a gap between the stator and rotor of the water pump. If used for a long time, water will penetrate into the motor and it is easy for the motor to burn out.
Advantages: The brushless DC motor has been standardized, with low cost and high efficiency.
3. Brushless DC magnetic drive solar submersible pump
The brushless DC water pump adopts electronic component commutation, without the need for carbon brush commutation. It adopts wear-resistant ceramic shaft and ceramic sleeve, which are integrated with magnets through injection molding to avoid wear. Therefore, the lifespan of the brushless DC magnetic water pump is enhanced. The stator and rotor parts of the magnetic isolation type water pump are completely isolated. The stator and circuit board parts are sealed with epoxy resin, which has good waterproof performance. The rotor part is made of permanent magnet, and the water pump body is made of environmentally friendly materials, with low noise, small volume, and stable performance. Various required parameters can be adjusted through the winding of the stator, allowing for wide voltage operation.
Advantages: Long service life, low noise up to 35dB or less, high temperature resistance, suitable for hot water circulation. The stator and circuit board of the motor are sealed with epoxy resin and completely isolated from the rotor, which can be installed underwater and waterproof. The shaft of the water pump is made of ceramic shaft, which has good seismic resistance.